We understand that it is difficult to remove some locks from their location in order to send them infor repair or modification. We offer these replacement solenoids as a possible solution. In most cases we recommend sending your locks in to Marray for repair and/or modificaiton. Any damages to the hardware upon installation will not be covered under warranty.
This is our patented dual voltage solenoid we have been using for the past few years. This product is used in our ND80 kit modifications as well as in our MARRAY GN series and Cal-Royal modified locks. The solenoid is 12 and 24 volt, as well as switchable from Fail Safe to Fail Secure.
This solenoid is also used in our Sargent ET trim modifications, as well as in our Von Duprin 33 series trim modifications. You would need to chose the correct product above, since the cam is different for each of these products, even thought the basic solenoid is the same.
We use this solenoid in our Baldwin Mortise Lock modification as well as the Sargent and Yale mortise locks.
NOTE: Baldwin, Sargetn, and Yale Solenoids will need slight adjustment on the customers part and any damages or losses will not be not covered under warranty. This option is not recommended for Baldwin since each lock is custom and varies slightly. Baldwin Locks are also spring loaded and once opened may be very difficult to put back together. We recommending sending your locks back to Marray for any repairs or modifications.
